Wiring Page 4
Started - 5.23.2001 - In progress
 |
Here we have the panel clecoed in to the aircraft. I am still waiting for some longer instrument screws, and for Microair to release their new Comm and Xpndr... |
 |
 |
Top right you can see the Encoder mounted on top of the map box. At right you can see the panel lowered and tipped. I am hoping this will work well for easy access to the back of the panel... |
 |
 |
I am using some clips that I got from Jerry Carter. He found them at Home Depot, but I was unable to find them at Home depot here. You can see another picture of this type of installation HERE... |
 |
 |
More pix of the panel installation. I got the static system plumbed and the turn and bank wired... |
 |
 |
At right you can see my ELT antenna installation. The ELT will be mounted on the rear baggage shelf - You can see pictures here... |
 |
 |
Wiring up the EIS was pretty easy with the pre-wired harness... |
 |
 |
There are a lot of wires that I will not need, so I bundled them up and out of my way... |
 |
 |
I got it powered up (with no sensors installed), ran it through it's self diagnostics, and played around with it for a bit... |
 |
 |
Garmin Pilot III Installation. I made a bracket to mount the GPS to my blanking plates. |
 |
 |
I made the bracket out of some left over .125" angle material. The mounting base that came with my GPS screws to it, and it screws to the blanking plates in my panel... |
 |
 |