Wiring Page 2
Started - 5.23.2001 - In progress
 |
The blue thing just about the conduit at left is the terminal block used to split the NAV light circuit between the three lights. At right you can see my switch console. I got the master, avionics bus, nav, panel, strobe lights, and dimmer wired... |
 |
 |
The Adel clamps work well for routing all the wires up around the fuse blocks... At right the battery is installed and you can see some of the ground wires terminating at the firewall... |
 |
 |
More wiring...
I got the flaps all wired up... You can see where I ran the wires as well as the pitot static tubing... |
 |
 |
I routed my wiring for the flaps a little differently. I didn't want to be able to see the wires coming up through the floor... |
 |
 |
I am using some Adel clamps for routing wires up to the fuse blocks... After I ran each circuit, I used a switching power supply to test it... Should be no smoke during the final test... |
 |
 |
All of the circuits in the RH switch console are wired. It's a tight fit to get all the wires zip-tied up out of site... |
 |
 |
Left; Battery compartment again. I will be zipping all these
wires up once the job is done...
Right; Pax map light and switch as well as the rear aux power... |
 |
 |
Here's the landing light wig/wag circuit in place... |
 |
 |
Battery connections made... I used a special crimper to attach the #2 connectors to the battery cables... |
 |