Finish Kit Page 4
 |
I did use some of the miles of the corrugated plastic tubing that Van's sent in the wiring kit. I ran one down the right side for strobe and tail light power... |
 |
 |
I used zip ties to hold the tubing in place... |
 |
 |
On the left side I ran one for the flap motor wires. I also drilled a hole in the floor under the flap motor so the wires don't have to be seen like the plans depict... |
 |
 |
I got my Ray Allen Company stick grips installed on the
sticks... These are really nice grips...
I also installed the F-830PP & F-831PP floors... |
 |
 |
I installed the center control column for the last time hopefully...
I also installed the flap motor and weldment... |
 |
 |
Rear seat throttle is in, the front quadrant is only in there
temporarily, I still need to drill the holes for the cables to pass to
the engine compartment.
You can also see the bracket I installed to hold the carb heat control... |
 |
|
|
|
 |
|
Here are some pictures of the cooling air duct routing... |
||
 |
I decided to go ahead and mount the tail... I had to turn the thing around and have the nose sticking out of the garage in order to do it, but it worked out ok... |
 |
 |
Once I got the fuse leveled, mounting the horizontal and vertical were pretty straight forward... It took me about a day and an evening to complete the job... |
 |
 |
Everything fit pretty good......I guess I did build the thing pretty
straight, not perfect, but I was able to get everything square...
I also mounted the rudder stops... |
 |
