Finish Kit Page 2
 |
Manual elevator trim cable installation. The instructions and drawings leave a lot to be desired in this area. I ended up calling Brian Denk for some help. Thanks Brian! |
 |
 |
The pix on the left are betting at showing where I ran the cable, and the pix on the right show that it is pretty much concealed once the panels are installed... |
 |
 |
As the cable passes under the rear seat throttle assembly, it will also be held by in place by an Adel clamp bolted through the throttle arm attach at the bottom... |
 |
 |
I haven't completely decided how to route it once it gets past the rear baggage compartment, I will work that all out once I install the tail and see how cable I really have... |
 |
 |
I finally decided to get he up on her gear this weekend... |
 |
 |
The engine mount went on like a dream... |
 |
 |
And once I figured out the axle, brakes, and fairing brackets, it all went together without a hitch... |
 |
 |
Running the fuel lines... This is a bit of a bitch, I had to make each of the two tank lines twice... |
 |
 |
I still need to clamp them in place with some Adel clamps and soon as I get them. I ordered some from www.tiewraps.com... |
 |
 |
On the right you can see the fuel pump feed line, I still need to bolt the fuel pump in place... |
 |